Official Luthiers Forum!

Hav`nt taken it out of the box yet, but it looks like it is in one piece. will have it braced in a day or two, then off to Paul W. I belive.

Matt

Yeppie!!!!!!!!!!!!!!!!!!!!!!!!!!!!

_________________
Support the OLF! Bookmark our STEWMAC link Today!
Lance@LuthiersForum.com

Lance, did you forget, it's a secret and you don't know anything about it. javascript:AddSmileyIcon('')
Matt, hope all goes smoothly and I'll email you with my address soon. Thanks Paul

No prob. Glad this project is moving again... (no thanks to me.)   

_________________
Brock Poling
Columbus, Ohio
http://www.polingguitars.com

or me....

_________________
"I want to know what kind of pickups Vince Gill uses in his Tele, because if I had those, as good of a player as I am, I'm sure I could make it sound like that.
Only badly."

Lance you and I need to work out the neck blank construction and the mortise and tenon, I might call you tomorrow when your in and we can work out the details. When *I* assemble the sides on my guitars I have a mold that allows me to fit the sides right to the edge of the mortise for the heel, however if you like to glue the mortise block in and then cut them out that is cool too.

Also I bury the truss rod nut down into the tenon so we will need to drill a hole in the tranverse brace so you can adjust the neck, however if you guys want it the other way I can do that too, I'm open to suggestions on this one.

I just want to make sure that what I build will fit with what everyone else is doing...

Cheers

-Paul-

_________________
-Paul-

Patriot Guitars